Page 1 of 1

Thoughts and comments

PostPosted: June 17th, 2012, 4:16 pm
by Daryl
I was looking at this cutter and wanted some feedback. I have been watch ebay/craigs list and other places for over 6mos. I am a little afraid of buying used. I saw this and wondered for a budget start up cutter if any body has any comments.
Daryl
http://heatpressvinyl.3dcartstores.com/ ... ert24.html

Re: Thoughts and comments

PostPosted: June 17th, 2012, 5:51 pm
by JESS
Daryl-
If you can, TALK to the seller. That's the best way to find out why it's for sale. :dunno: Just my 2 cents-
Jess

Re: Thoughts and comments

PostPosted: June 19th, 2012, 1:02 am
by Inga
I don't know. . .at 250 gms, it seems a little low on downforce. You will be quite limited in the stencils it can handle.

What are the other two low end machines. . . COPAM and MASTER, right?
ALthough I am not totally up on the newer machines, I would check them out, I think they have developed a bit of a track record.
Anybody else?
THanks,
Inga